Natural Kote V2 ENAMEL Acrylic Urethane Stain for Interior & Exterior applications Non-hazardous (Replaced Price 620 Urethane)

Why buy stain online?   All of our A&L Paint Co. products are shipped to you FRESH, directly from the small batches of premium paints and stains made on an Amish Farm in Pennsylvania and shipped directly to you from the manufacturer!

V2 ENAMEL Acrylic Urethane Stain was specially designed for use on primed siding such as LP Smartside, Primed Duratemp, James Hardie Board and Cement board sidings. It enhances the textured grains and gives the appearance of real wood!

But it has a broad application being safe for Interior & Exteriror applications on wood, metal and fiberglass.  Non-hazardous

• Enhanced UV stability for superior exterior durability
• More flexible than traditional urethane, preventing cracking and peeling
• Enhanced scuff and abrasion resistance

Note: Also available in 55 gallon drums, perfect for large-scale projects and contracting needs. Contact us for pricing.

Application Instructions

Temperature
The ideal room and product temperature is between 60- 80 degrees. Warmer room air temperatures may cause the coating to dry too quickly at the edges of the spray fan causing a dusty over spray. Cooler temperatures will slow drying times. The NaturalKote V2 Enamel temperature should be similar to the room temperature for best results. Substrate temperature should be consistent with the room and coating temperature. The siding must be dry and free of dirt or dust. Consistent temperatures of the spray room, coating and substrate are important for the proper application of NaturalKote V2 Enamel.

Equipment
Spray equipment must be maintained and working properly for best results. We recommend using a 415 or 417 tip. Equipment recommendations are general and can vary with the personal preferences and requirements of each person doing the application. We recommend that those doing the application experiment with different tips and find what works best for your situation and circumstances.

Application
Stir/Mix thoroughly before using. For semi-transparent look apply one coat on pre-primed surfaces. For solid look apply two coats. We recommend two coats on previously unpainted surfaces. Allow the first coat to dry before applying a second coat. We recommend priming bare metal with a rust inhibiting primer then apply two coats of NaturalKote V2 Enamel. Begin by making sure your sprayer pressure is correct. Spray a test panel and lower the sprayer pressure until there are fluid streaks at the outside edge of the spray fan. Gradually increase the pressure until the streaks go away. Make a note of the pressure for future reference.

Different sprayers may require different pressures so be sure to test a new or different sprayer before spraying a barn.

Apply the first coat with even, up and down strokes holding the spray fan in the center of each groove in the siding. Fan width and coating volume may vary a little depending on your tip and equipment but with the recommended tip sizes there should be very little difference. Wait until the first coat has dried enough to be just a little tacky and apply the second coat. Apply the second coat a little heavier than the first by going a little bit slower.

Ventilation
Ventilation of the spray room is critical for timely drying of the NaturalKote V2 Enamel. The spraying process of this waterborne coating creates moisture in the air that needs to be ventilated out of the room for quicker drying. Air movement needs to be through and out of the spray room, not just around the spray room. The best way to do this is to have a fresh air intake of some kind, even if it’s a window or door, and exhaust fans at the other end of the room blowing air to the outside. The more moisture you move out of the spray room with ventilation the quicker the coating will dry. The less air you move through the longer it will take to dry. Humid and colder air will slow drying times.

Product type: Waterbased Urethane/Acrylic